TVM50 Expansion from 2 to 4 port

[brotech]

I am looking for advice on the process to add more capacity to the TVM50.

I installed the 2 port expansion card in the VM unit and have it connected to a digital port in the TDA30.

i had hoped that when i did the reboot it the TDA would see the new ports in the TVM...but it does not appear so.

I suspect there is programming required in both the TVM50 and in the TDA30.

Hopefully someone can point me in the right direction.


Thanks in advance

 

[Ired]

You have to change the type of digital ports at your TDA30 from "Normal" to "VM(DPT)" and assign a correct numbers to this ports (according with port numbers at TVM50).

 

[brotech]

Thanks IRED

Your picture looks a little different from mine. Are you using a Digital port for each Channel IE 4 ports for 4 channels?

I am of the understanding that 1 Digital port supports 2 Channels. I will snap a picture when i get back to site.

Maybe this is my problem as I am having an issue getting a Ring Group to forward to the Voicemail box that I set up for that Ring Group on a consistent basis.

I will send pictures asap, thanks again

 

[brotech]

Here are the pics.

 

[Ired]

Your picture looks a little different from mine. Are you using a Digital port for each Channel IE 4 ports for 4 channels?

I don't use VoiceMail at all - that picture was just for example.

 

[brotech]

Thanks Ired...are you able to confirm my understanding that 1 digital port will support 2 VM Channels?