Turning up MOH 2

[Mamoose]

Definity G3siV11
Music on hold was once working in my switch and it got deleted.
I can't find out how to get it back working.
I know where the jumper from the music source is, but it was cut.
As I remember this goes to a TN763. right?
How do I add an MOH line to the TN763?
Thanks

 

[PBXTech]

ask and you shall receive...

http://www.tek-tips.com/viewthread.cfm?qid=490364&page=1232

 

[mikeydidit]

Thanks for taking the time to look up and post the solution for them PBXTech.

When is the last time you helped someone, just because you were able to?

For the best response to a question, read faq690-6594

 

[Mamoose]

Thanks guys I searched for it and couldn't find a match.

 

[wellco9530]

Pretty simple:

List config on your TN 763 circuit pack to see which port is available for use.......

Run x-cut from music source to that port i.e: port 2

"change system features"....enter this port on line for Music/Tone on Hold

You should be good to go....

* Make sure on your COR's that "Hear System Music on Hold" is "y"

Good Luck