Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

TTY/CDR Flow Control

Status
Not open for further replies.

oneeyebrow

Technical User
Mar 7, 2011
42
US
Hello, I am trying to configure the flow on the below TTY port. I can enter YES at the FLOW prompt, but there's no option to configure, BPS, BITL, STOP and PARY.

ADAN TTY 3
CTYP QSDI
DNUM 3
DES
FLOW NO
USER CTY
XSM NO

Any suggestions would be appreciated. Thanks.
 
The reason is that you are viewing the TTY port details from Quad SDI card. The baud rate is changed by dip switches. These are found on the larger option 51 to 81 cube systems.

All the best

Firebird Scrambler
Meridian 1 / Succession and BCM / Norstar Programmer in the UK

If it's working, then leave it alone!.
 
Thanks. This in an Option 11c. There are TTY ports that are CPSI cards with baud rate settings. Can CDR be used for one of these?

Thanks again.
 
Do u have an SDI card in the system ? Or r u using the port in the expansion cabinet?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top