trying to set up a pri to a Taqua-OCX switch

[WYREDAWG]

i have configured the card and connected it the Taqua switch. Looks like layer 1 is up cause everything greens up . but when i go to LD 96 to check the DCH it is in an RLS AUTO state. everytime i try to establish it , i get an error stating that it is in a wrong state. the Taqua switch is set up as Network and the Option 11c is setup as user. is there anywhere to check the type of isdn protocol that the pbx is using?

 

[johnpoole]

you can't enable the dch because it is up and waiting for the other end. disable it and bring it back up. the adan will have the switch type, ld 22 prt adan dch x. the ifc type and rls must match the far end. that sets you protocol type. at the side prompt one end need to be usr and the other side net. after you make changes on the dch you must disable the msdl and do a ld 96 enl msdl x fdl. the full down load prompt will rewrite the config change to the eprom on the card.

john poole
bellsouth business
columbia,sc

 

[WYREDAWG]

we were able to get the d channel going, didnt change any settings on the option 11c side. i set it up as an ESS5 and it popped right up when the completely rebuilt their side. thanks for the input anyway .