Trunk to Trunk

[Haver1]

I am trying to connect two analog trunk lines through the IP500 running CM 6.1. I need the the switch to route the connection right back out to another analog trunk and flash the line. Can anyone advise on how to do this?

 

[Westi]

you are confused, IP500 doesn't run CM (CM is S-series)but no worries about that.
you would need voicemail pro do do something like that but why not take the line and forward it through the line provider.

Joe W.

FHandw., ACS

If you can't be good, be good at it!

 

[Haver1]

Confused I am. I do have VMPro and have not tried to use it for that purpose. I was want to control the connection locally so I may route the lines using the short codes or ARS. Is this possible?

 

[amriddle01]

Give us the bigger picture, why do you want to flash the other line as oppose to just routing too it? We may have aletrnatives.

ACS - IP Office Implement

"I'm just off to Hartlepool to buy some exploding trousers

 

[Haver1]

I am flashing the line to select a local DECT wireless network. The wireless base requires a flash to select one of two nodes. I need to route a incoming analog trunk through the switch to another analog trunk then apply the flash. At this time the line just rings and stops. I have setup Incoming route and short codes but it doesnt seem to apply them. When I do a trace it just list the incoming port.

 

[IPOfficeIreland]

trace the active call not the trunk.

what short codes are you using

 

[Belrick]

Shortcode feature flash hook...