Trunk Testing

[digitalgear]

I have an err090 60 0 0 1 29 11
The error is telling me to check the central offic e for a bad trunk.
I did some troubleshooting and found it is Route 35 which is a TIE and it trunk 25 member 11. What is the best way to test this type of trunk? Any help is greatly appreciated

 

[SYQUEST]

I have had this error in the past on an OP61C w/tie trks on T1 facility. It seemed to be kind of erroneous, because I could never find anything wrong with the trunk(s). This setup used the trunks between two OP61Cs and most of the calls were then outgoing to co trunks. Depending upon the type of facility your tie trunks ride(T1 or copper) you could put some testgear on the trunk to monitor it. For T1 you need a channel access testset, for copper you would need a 'BERRY BOX' or a 'TIMMS' to observe conditions on the trunk. Then place test calls or just watch the traffic as the trunk is used and listen to the call progress.

 

[Mpking]

SyQuest is correct.

However, you can also directly access the trunk two ways.

Create a 500 set. Give it a CLS of TVA

pick it up and dial SPRE + 70 + ACOD + mmm
where mmm is the trunk member that is to be siezed. mmm MUST be 3 digits. (eg, dial 001 for member 1)

Second way is a little harder, Use set based Admin, goto load 32, and pickup the trunk you want to use.