Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Trunk from srg50 to cs1000

Status
Not open for further replies.
mattia81

mattia81

Programmer
Apr 19, 2006
12
IT
I configure the srg and cs1000 but i can' t call from srg50 to cs1000 on trunk ip.
 
Sort by date Sort by votes
Try setting the payload size, in the BCM to 20 for any codec you are using. Worked for me.

NARSBARS
 
Upvote 0 Downvote
Is the SRG registered to the NRS? Take a look in the NRS and see if that endpoint is defined and shows as registered. I'm guessing that your sets aren't redirected (still in local mode). Make sure you have your main office DN prefix built as digits against the main office endpoint as well.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

MoJHK
  • Locked
  • Question
Emetrotel SIP trunk to IPO500V2
Replies
1
Views
122
curlycord
curlycord
AShammah
  • Locked
  • Question
BCM50 Voip.ms sip trunk & call route setup 1
Replies
10
Views
203
AShammah
AShammah
Rosesam
  • Locked
  • Question
BCM450 sip trunk wants to do Direct Sip only
Replies
3
Views
127
Rosesam
Rosesam
linsha
  • Locked
  • Question
Calling from CS1K to Avaya red using 5 digit extension
Replies
1
Views
87
Firebird Scrambler
Firebird Scrambler
curlycord
  • Locked
  • Question
BCM450 from heaven 6
Replies
16
Views
360
Westi
Westi

Part and Inventory Search

Sponsor

Back
Top