I have a 406VS PCS 09, 2 X 30 port digital exp. 1 X 8 POTS. New install I have had the system up and running for over a week. Cut the PRI over few days ago, and then activated all sets today. Had 1 set in the wrong port plugged in a tone generator (Entire unit is earth grounded and on a line conditioner) came over to the switch minutes later. The light 1 of the digital station 30 that hosted the set I was tracing kept going red, green and then blank consistantly over and over. All sets dead on that this digital station 30. DTE the unit AT-X2,3 and the rest. Still did not come up. Checked the power sources, outlets, expansion port switch, cables, everything. Still the same result. Finally just left the unit unplugged. A few hours later unplugged all sets to the module to swap it out. Curious I plugged the module in on it's own and it came up with everything and not even down graded.
Can anyone explain this and should I get another module or should this be okay. Has anyone had a similar exp.
Thanks
Can anyone explain this and should I get another module or should this be okay. Has anyone had a similar exp.
Thanks