Can someone help me out here. I tried adding a printserver to one of our sites but it is not going as smoothly as i anticipated. for some strange reason it is not pulling the correct IP address or Subnet Mask and Gateway address. Ive tried resting the device a million times but it will not budge. It is pulling an IP address (the wrong one) but when i try to ping it i get some timeouts and some replys, it is very inconsistent. does anyone know what could be the cause. the site is setup a little strange but works. we have a cisco router with a linksys router connected to it. the linksys hub has 3 pc's connected to it. then we have a belkin hub uplinked to the linksys router. the printserver is connected to the belkin. any help is appreciated.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Trouble setting up a Linksys PPSX1 printserver on the network.
- Thread starter Dherrera
- Start date
hi,
You are configuring this Pserver under which Operating System?If under(98,ME or 2000)use the 'win9x_nt'or 'ptp'driver from the setup disc or install the Bi-admin under WinXP.Once the Bi-Admin detected the Pserver,assign it with a Static IP,netmask and Gateway.
Then proceed on adding the Printer using the Standard TCP/IP...Hopes this help.
You are configuring this Pserver under which Operating System?If under(98,ME or 2000)use the 'win9x_nt'or 'ptp'driver from the setup disc or install the Bi-admin under WinXP.Once the Bi-Admin detected the Pserver,assign it with a Static IP,netmask and Gateway.
Then proceed on adding the Printer using the Standard TCP/IP...Hopes this help.
- Thread starter
- #3
- Status
Similar threads
- Locked
- Question
- Locked
- Question