Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Transfers to attendant consoles shows a "T" and a "H" in the 1

Status
Not open for further replies.
kce9751

kce9751

Programmer
Nov 18, 2008
59
US
This is a CS1000M MG on 5.5 software. When the user transfers an external call to the operator(there are 3 of them using 2250's), a "t" or a "h" appears at the end of the clid. Does anyone know why that T and H appears. It seems to have just started. Thanks.
 
Sort by date Sort by votes
Transfer" or "Hunt" I suspect. You can see the codes here:

LD 95
REQ PRT
TYPE CPND

~~~
[small] [©] GHTROUT.com [⇔] A Variety of Free Resources for Nortel Meridian/CS1000 System Administrators [/small]
 
Upvote 0 Downvote
Transfer/Hunt. You may also see CFNA when a phone is Call Forwarded back to M2250.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Rosesam
  • Locked
  • Question
SS "Please upload an appropriate load"
Replies
6
Views
176
Rosesam
Rosesam
Mokpokpo Agbovon
  • Question
Replace M2250 Consoles with 3904 Digital Sets
Replies
5
Views
346
gbtac3
gbtac3
phonetech2012
  • Locked
  • Question
no incoming calls to DID's that start with a "1" 1
2
Replies
20
Views
308
Michael OConnor
Michael OConnor
Emara
  • Locked
  • Question
when dialing the access code and th
Replies
1
Views
171
Firebird Scrambler
Firebird Scrambler
telepath
  • Locked
  • Question
Change the SIDE to NET of a DCH 1
Replies
3
Views
140
telepath
telepath

Part and Inventory Search

Sponsor

Back
Top