Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Transfering to hunt/coverage group

Status
Not open for further replies.

KenMeans

Vendor
Mar 6, 2003
3,357
US
MM 5.1 system with exchange and T-1 QSIG on S8500. When it was at 3.1 it would transfer to hunt group ext and that was forwarded to an off site number. Now on 5.1 it just comes back and tells you it is busy. It is now set to a VDN that is sending it to the outside number and that works but we are trying to figure out what the deal is with the hunt group.

Any ideas ?

Ken Means

"I find that the harder I work, the more luck I seem to have."
- Thomas Jefferson (1743-1826)
 
Ken, I know you know this, but you might double check to make sure that on in the VMSC > PBX > Outcalling tab that it's set to mulaw - I just ran into this - drove myself nuts troubleshooting only to find out I forgot to change it from alaw.
 
Checked it and it is set right.

Thanks

Ken Means

"I find that the harder I work, the more luck I seem to have."
- Thomas Jefferson (1743-1826)
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top