jacksonsmom
IS-IT--Management
After I installed the 1140 set and was testing, I noticed that the transfer key is not working. When you press the key to transfer it gives the beeps similar to conference calling and will not transfer. I would like the to do a blind transfer as on the 2616/2008 sets using TRN in the programming.
Is there programming that is needed even though TRN is programmed on a soft key automatically?
Thanks for your help - I am new to the IP sets.
Is there programming that is needed even though TRN is programmed on a soft key automatically?
Thanks for your help - I am new to the IP sets.