Having difficulty logging onto a switch. What was working yesterday isnt today. Logged on to tracker and got system prompt 1> then typed :IT0. Then at the next command prompt typed :ME. Then it replies with 'OK@ . I hit return but no response. I would like to get a hold of the manual. Can anyone point me in the right direction? Thank you
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
TRACKER COMMANDS
- Thread starter sk1053
- Start date
MattRutter
Vendor
The fact that you get nothing after ;ME sort of indicates that there is nothing connected to the port!
However, it's not unknown for the port to hang. You can usually clear this by issuing the folloing two commands:
;CM N,Y,N,Y <RET>
;CM N,Y,N,N <RET>
This effectively unplugs the cable into the port and resets the port.
There is NO echo for these commands!
Hope this helps
Matt
However, it's not unknown for the port to hang. You can usually clear this by issuing the folloing two commands:
;CM N,Y,N,Y <RET>
;CM N,Y,N,N <RET>
This effectively unplugs the cable into the port and resets the port.
There is NO echo for these commands!
Hope this helps
Matt
- Status
Similar threads
- Locked
- Question