Tone board in Major Alarm

[Blight]

Came in this morning to a Major alarm... Says it was the Tone Board @ 10A. Went and replaced the tone board major stayed... replaced it again... Alarm didnt clear. Any ideas what could be causing it?

I know that from previous replacements of tone boards sometimes that have to be "Activated." But I can't for the life of me remember the command... anyway any help would be appreciated.

 

[4merAvaya]

Try running 'test tone-clock 10a'.

Kevin

 

[Blight]

Test No. 46 Fail - Everything else passed.

 

[4merAvaya]

Page 2368 starts the repair process for Test 46.

Kevin

http://support.avaya.com/elmodocs2/comm_mgr/r3_1/pdfs/maintenance/03_300430_2_1.pdf

 

[Blight]

thanks that fixed it... 3 more alarms to go that i have to get cleared before I can upgrade to 8720's

 

[mikeydidit]

It sounds like that system is limping pretty bad and it may be time to upgrade it.

"A people that values its privileges above its principles soon loses both."
- Dwight D. Eisenhower (1890-1969), Inaugural Address, January 20, 1953

For the best response to a question, read faq690-6594

 

[Blight]

yea well, it was much worse off... 21 cabinents G3R V11.1 hasn't been taken care of properly in probably 10 years... I took over 6 months ago and have been trying to clean it up, but its a complete mess... its in much better shape now then it was when I took over... if you can believe it... lucky for me we are upgrading to 8720's on the 26th.