We have an office with a SX2000 that is overtrunked and the powers to be wants to disconnect the T1. I have routed all outgoing calls away from it to another trunk group and now I am in a holding pattern for them to move the TF numbers coming in on it. My question is how to dismantle the programming...my first step would be to busy out the trunk and then delete the members in the Trunk Group Assignments and then the same in Trunk Assignments. It also has a digital link assignment and I just noticed that under the Network Synchronization form it is being used as the first clock source. When this T1 is removed, the office will be using LS/GS lines - if that is the case, does the PBX need a clocking source or can it use its own internal clock? Any suggestions? Thanks.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
To Remove T1 Programming SX2000
- Thread starter taylorjr
- Start date
No you will not need a clock source if no digital trunks
delete the ars
delete the route
delete the digit mod
delete the trunks
delete the netsynch entry
delete the trunk service
delete the circuit descriptor
delted the digital link assingmnet
delete the sytem config form entry
delete the link descriptor
do a datasave when you are done
delete the ars
delete the route
delete the digit mod
delete the trunks
delete the netsynch entry
delete the trunk service
delete the circuit descriptor
delted the digital link assingmnet
delete the sytem config form entry
delete the link descriptor
do a datasave when you are done
- Thread starter
- #3
- Status
Similar threads
- Locked
- Question