TN2602AP "Super Med-Pro" Any Issues???

[cduff]

Has anyone seen any issues using these new circuit packs? Is it worth moving over from the TN2302AP's to gain more carrier slot space.

 

[4merAvaya]

You have to be CM 3.0 to use the TN2602. The licensing is a little crazy (80 or 320 calls).

Kevin

 

[phoneguy55]

How many old medpro's do you currently have installed?

One thing I like about the medpro's is that they will load balance when you have 2 or more. This is nice just in case one dies you have another to back it up. If you are thinking of replacing all you old medpros with only 1 TN2602, I would think again.

 

[Tolson]

One other important fact is that you can only have two ofthe in an EPN.

 

[cduff]

But are they stable

 

[Dunstan]

Yes, they are stable.

 

[wildcard100001]

Eariler firmware versions were not... My DSP channels would eventually lockup... the board would go down, then back up... but I now have:

TN 2602AP - HW02 FW012 - very stable, no problems at all.

Thanks,

Wildcard

 

[johnnydialtone]

We used FW021 and had problems with analog stuff. Backed off to FW012 and analog works again.