Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

TMDI will not enable

Status
Not open for further replies.

jagartner

Technical User
Aug 5, 2010
26
US
I have a CS1000E 6.0. I have the TMDI's in slots 0 1 3 and 0 1 4. The card in 0 1 4 will not enable. I tried several times in ld 96 and ld 48 to enl tmdi 0 1 4 fdl. After I hit the enter key after entering enl tmdi 0 1 4 it just sits there. I dont even get a message. Any thoughts. The TMDI in 0 1 3 has the clock controller.
 
I forgot to mention that this is the 3rd card I have tried. All three cards work in other systems.
 
INT THE SWITCH

OLD ROLMEN WORKING ON NORTELS AND AVAYA
 
I have INT the switch many times. Here is the CEQU


REQ prt
TYPE cequ

CEQU
SUPL V000 N156 V164 V168
V172 V176
SUPC
SUPF
XCT
CONF
MGTDS IPMG IPMG_TYPE
124 000 0 MGC
126 000 1 MGC
128 000 0 MGC
130 000 1 MGC
MGCONF IPMG PORTS IPMG_TYPE
125 000 0 30 MGC
127 000 1 30 MGC
129 000 0 30 MGC
131 000 1 30 MGC
MFSD * 124 * 126 * 128 * 130

DLOP NUM DCH FRM TMDI LCMT YALM T1TE TRSH MG_CARD
PRI 020 23 ESF YES B8S FDL 0 00 000 1 03
021 23 ESF YES B8S FDL 0 00 000 1 04
DTI2 MG_CARD
MISP MG_CARD
EXT0 3PE
EXT1 3PE
MCFN 006 MB
 
Make sure all services, if any, in that TMDI card are disabled by using LD 48 and stat TDMI 0 1 4 full. If any of the services state shows ENABLED, you'll have to disable each one individually until all services are diabled. It won't hurt to reseat the TMDI card. Afterwards, issue the command enl tmdi 0 1 4 fdl and after a few seconds, you should see a response. If that happens, then enable the services individually. Enable associated d-channel then the loop. Hoe this helps.
 
Whoops, I missed a step. After you reseat the card, then disable it using the dis tmdi 0 1 4 command. Now, at the dot prompt, enable the card and each service.
 
I will try on Monday morning. Thanks for your responses.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top