Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

TMDI Install

Status
Not open for further replies.

sarakodi

Technical User
Mar 29, 2006
38
US
I don't have the correct cable to connect the TMDI card to the circuit so I'm going to use a 25 pair cable
does any one know what pairs I would cross connect to until I get the correct cable?

Thanks in advance
 
what are you installing it in? (cs1000m, E, meridian?)

Mato' Was'aka
 
1 and 9 ----> 4 and 5 (green and red)
3 and 11 ----> 1 and 2 (blue and orange

or

1 and 9 ----> 1 and 2 (blue and orange)
3 and 11 ----> 4 and 5 (green and red)

Mato' Was'aka
 
I stole this from another site..didn't want to look it up in NTP.

On the 25 pairs 50 pins cable.

Pin 48 Pin 1 Pin 5 T transmit tip to network
Pin 23 Pin 9 Pin 4 R transmit ring to network
Pin 25 Pin 2 N/A FGND frame ground
Pin 49 Pin 3 Pin 1 T1 receive tip from network
Pin 24 Pin 11 Pin 2 R1 receive ring from network
 
I'm not using a DB15 I'm going to connect a 25 pair cable to the port I'm installing the TMDI card into and then I'm planning on punching down the 25 pair cable and cross connect a patch cord just to get the circuit up and running until we get the correct cable.
 
Thanks SSJVirus007
I think thats what I need
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top