TMDI and PRI

[jpet621]

I’m hoping someone can help me program a TMDI to accommodate a PRI. I created a loop and a route but when I try to add channels it won’t let me. There are So many settings in the loop and route programming I don’t know if I got them correct
Can someone steer me in the right direction
Thanks in advance

 

[bhassell2000]

is the Loop a TMDI loop in CEQU?

Thanks,

Buddy

Linked in Profile

http://www.linkedin.com/in/buddyhassell

 

[jpet621]

I’ve done more work on this. There’s is actually a t1 on a tmdi card now Loop 2. I created a PRI Loop 1 and built a Route and assigned the channels to it. When I enable the loop all my channels say idle but I have a red CC light on my card My clock is set for primary from the t1 and secondary as free run. Should I make secondary the PRI?
Sorry if I’m way off base. First time dealing with this
Thanks

 

[bhassell2000]

Do you have a clock controller on that card? If not it will be red. You can add the other PRI as secondary in ld 73


Thanks,

Buddy

Linked in Profile

http://www.linkedin.com/in/buddyhassell

 

[jhanniga]

Mike has a nice cheat sheet

https://pbxbook.com/meridian/install/t1_install.html

 

[jpet621]

Ayer doing some digging I found using 2 tmdi cards the clock controller needs to come off one of them and set the primary to the one installed. Good news is my card is up bad news is I can call in on a DID no problem but when I use the access code to dial out it times out and I get a busy
Any ideas?

 

[jpet621]

Just wanted to add when I dial the access code and get second dialtone, dial s number and it times out.
Then I get error code err404 0

 

[KCFLHRC]

Make sure you have something programmed in the LDN_DATA

LDN0 XXXX where XXXX is the amount of digits being sent to the PBX from the CO