TM-T88iii and drawer kick problem

[stevebanks]

Hi ,

I am using the generic/text driver to try to print from a TM-T88iii and am getting all the data i need printing out on the receipt, however, I cannot get the cutter to work, or the drawer to kick which is going through the printer? I am using windows XP

I have tried with the hexadecimal that has been suggested
but i am a little stuck as it is not working?? Could someone possible guide me through a little?

Thanks

Steve

 

[alohaakamai3]

This will probably be of absolutely no use to you, but I will post what I know. In order to get the cutter to work on the Epsons, Dip Switch setting 2 must be turned on, on the bank of switches marked DSW2.

I would make sure that is turned on (and usually the rest off, in our case), and try your code again.

 

[19972003]

Hi, I have the same issue, will your suggestion apply to this printer?

EPSON TM-T88IV

Thank You,

 

[Circle9]

Look at the following PDF for the codes you can set up in the Windows printer driver section.

http://www.positive-feedback.net/FreePOSGenericText.pdf

 

[19972003]

Thanks,I changed the print setup "disabled print full page" and it print out fine, but it prints two receipts, the first one is blank and 2nd one has the proper amount; unfortunately the drawer still doesn't kick at all. Any other thoughts?

Thank You,

 

[DTSMAN]

OPOS drivers?

Bo

Remember,
If the women don't find you handsome,
they should at least find you handy.
(Red Green)

http://www.redgreen.com

 

[19972003]

I used the MS generic text driver (Epson driver didn't work at all, it prints so slow), I can't think of anything else I can try now.

 

[19972003]

to clarify, the OPOS driver doesnt work at all, we are using the CSI software.

 

[stevebanks]

Sorry... where can i get the CSI Software that you are talking about?

thanks

steve

 

[19972003]

http://www.csisoftwareusa.com/company_contact/index.php

 

[19972003]

Anyone has more suggestions in regards of the Epson TM-T88IV printing problem?


Thank You,

 

[19972003]

is there a way to adjust the width of the receipt when it prints?