Hello, I have changed the time on a Partner system today...Time will change after programming...About 10 minutes later it goes back the old time (1 hour forward)...Took daylight savings feature to not active and reprogrammed...same thing happened...any suggestions on what is going on?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations SkipVought on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Time not changing on Partner system
- Thread starter mtel
- Start date
Telecomboy
Programmer
Partner R6? It synchs to the inbound caller id. So, the first call that comes in that is wrong, it changes to that time.
- Thread starter
- #3
Wasn't the TOD clock sync to Caller ID feature added starting with the R7 "J" software release ![[ponder]](/data/assets/smilies/ponder.gif "[ponder] [ponder]")
.
But either way, incorrect time stamps from a service provider will cause the TOD clock to change with an R7 and R8 processor. The ability to override the auto-sync feature was added to the R8 processor.
I![[love2]](/data/assets/smilies/love2.gif "[love2] [love2]")
"FEATURE 00
. But either way, incorrect time stamps from a service provider will cause the TOD clock to change with an R7 and R8 processor. The ability to override the auto-sync feature was added to the R8 processor.
I
"FEATURE 00- Status
Similar threads
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question
