You should be able to so this, I would set the T1 trunks to E&M with auto answer turned on. This way you should be able to dial between the 2 of them with just extention numbers.
I think you'll need to setup a destination code and routing to dial from the Norstar to the Legend. I seem to remember having to setup Target lines to receive calls from the Legend. Hopefully someone here can verify.
Exsmogger is correct about the routing. Set up a route to use the tie T1 and then destination codes that match the Legend extensions to use that route. Set it to discard no digits. If you have conflicts between the extensions on the two you'll have to use a prefix code and have the route discard it.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.