Tie 2 G3's with simulated T1

[maverick2689]

I have house pairs between 2 G3's (1 an r9.5, the other r10). Can I use 2 pairs of this and "simulate" a T1 or PRI? I've done this with a Magix before, but not Definity. I have TN464F's with 120A3's in both switches.

And if so, can some one give me a complete idiot's guide to how to make it work? I've added ds1's as PRI, built trunk groups, and now I"m lost. MY BP is suddenly MIA,and I need to get this set up as part of our Intuity deployment.

Any help is much appreciated. I can be reached here, as it may be helpful to others, or at kaumell@shsny.com.

TIA

 

[1a22ip]

Just swap pairs 12 with 45 on one side only. Build the isdn trunks the same and don't forget the signal group as well.

Hope this helps
ED

1a2 to ip I seen it all