Hello all,
I am a complete newbie to this side of telephony. We are implementing new tele/data service to our client and testing the circuit tomorrow. We had a cut-over planned for the following day, but unfortunately the provider decides they can't schedule a port of numbers until 1 week after the install day. For a reason I do not understand, my boss tells me that if the clients lines are loop start we aren't in any trouble (meaning we can cut-over the following day without worrying about the lack of porting). My job is to go there tomorrow and test the new circuit, and then with a butt-set test for either loop starts or ground start. No problem with testing the new circuit, but tbh, I barely know what I'm doing regarding the loop starts. Can anyone help?
I am a complete newbie to this side of telephony. We are implementing new tele/data service to our client and testing the circuit tomorrow. We had a cut-over planned for the following day, but unfortunately the provider decides they can't schedule a port of numbers until 1 week after the install day. For a reason I do not understand, my boss tells me that if the clients lines are loop start we aren't in any trouble (meaning we can cut-over the following day without worrying about the lack of porting). My job is to go there tomorrow and test the new circuit, and then with a butt-set test for either loop starts or ground start. No problem with testing the new circuit, but tbh, I barely know what I'm doing regarding the loop starts. Can anyone help?