Test 136? T1 Circuit board test-

[98Converter]

I am installing a new T-1 and when I test the board, test number 136 has an "ABORT" result with error code 1005. Well I've located the error code, but can't find reference to the test 136 in the Maintenance Guide. With that I'm not confident the error I found applies the same to this test.

Any information out there on it?

Everything else is passing (138-146, 1227 & 36).

As always thanks, in advance.

Regards,
Chris

 

[MKU]

Hi Chris,

I think you've got your new ds1 board configured in an incorrect trunkgroup setting. See quoted error discription:

1005 ABORT Test failed due to incompatible configuration administered in trunk group
form.
1. Verify the following fields on the trunk group administration screen:
a. Is trunk direction incoming only?
b. Is trunk outgoing type either automatic or immediate-start?
c. Is trunk the 24th port of the DS1 Interface circuit pack while common
control channel signaling is specified?
2. If the trunk has been administered using the above information, then this
test should abort.