I am going to purchace a temp Monitoring system and it comes with bulb and "flat" sensors...i was wondering if i could put this "flat" sensor in between the heat sink and the prosessor without the following problems...
1. it will swish it and kill the probe
2. the heat transfer from the CPU to the heat sink will be affected (it says it has thermal tape, but i still dont know)
I also want to know if i can do the same thing with the video card processor, (stick it in between the sink and the chip)
Thanks,
Matt
1. it will swish it and kill the probe
2. the heat transfer from the CPU to the heat sink will be affected (it says it has thermal tape, but i still dont know)
I also want to know if i can do the same thing with the video card processor, (stick it in between the sink and the chip)
Thanks,
Matt