Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Tektronix Phaser 740L Transfer Kit Error 1

Status
Not open for further replies.

engineer350

Technical User
Sep 10, 2012
2
GB
When I turn on the printer I get the following error message

"Transfer Kit Error - Error 33

When I press the info button on the printer I get the following

1 - Reseat Transfer Roll

2 - Cycle Power

3 - Call for Service

I have read other posts on the site and cleaned, lubricated and checked all the clutches, I have had the transfer roll out many times and I cannot see a problem it is seated OK and the gearing turns it, can anyone please help
 
Thanks for getting back to me.

I have already checked both relays they were gummed up, I have cleaned these up and they do not stick.

When the clutch operates with the flag it always stops in the middle of the U shaped sensor, the magnetic clutch I have had this off and applied 24-volts it also operates fine and does not slip, the other two clutches I have stripped these down, they are free one way and only work one way but I still get the same error
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top