TDM Bus S8400/G650

[BoyRacer1001]

Setting up a new single G650/S8400 on ACM 5.0
All is OK, except no TDM cards are recognised by the system (Disp Circ or List Config all etc.)
IP Cards - Medpro, CLAN, VAL are OK, and so is TN771 Maint card - all are showing up.
No alarms in system.

Get 2 aborts (1005 code) with test Tdm-bus port-xxx but see this on working G650's also.

Any ideas???

 

[4merAvaya]

Are the Bus Terminators installed?

Kevin

 

[BoyRacer1001]

Yes, both terminators. 8400 has latest patch loaded, same wth IPSI and other IP cards.
Tried 3 different cards, different slots etc, all the obvious, but obviously missing something.

 

[Mitch672]

Did you enable IP port network control?

"change sys ips"

stroke it to "y", save the form

mitch


AVAYA Certified Specialist

 

[BoyRacer1001]

Yes this is set correctly.
Went ahead and got IA770 up and running, so VoIP OK.

Have manually reset the SIPI and re-programmed for static IP, still no change.

 

[Mitch672]

you do have the paddle board inserted correctly to address it to Cabinet A, and of course you have checked it?

You might just have a bad SIPI or a defective backplane, if everything else has been tried.

mitch


AVAYA Certified Specialist

 

[BoyRacer1001]

Problem turned out be the License file location setting, was set to US, so wouldn't recognise Europe boards. Silly mistake, hopefully learned and not forgotten....

 

[Mitch672]

you didn't say you had "BCS" or "B load" cards (TN2214, TN2464, TN2793, etc). If you had given us that tidbit of information, I would have told you to change the "location" field in the license to "2"

mitch


AVAYA Certified Specialist