tde600 1

[tde600]

Hello. What is the difference between link tde600 & tde600 by e 1 or dsp and which is the best

 

[obtsystems]

I would say use the dsp and ip gateway trunks, all you need is a vpn on broadband to link the systems and they can be set to use G.729 codex per channel instead of 64K, this will half the bandwidth needed. We don't have the E1 over here but isn't that the same as pri, so you would need special routers to link the systems

 

[tde600]

Thank you for the quick response
I have link with fiber& 2 tde 600 the distance between them about 800 m & I have E1 card for each pbx & 2 LCOT16
Can I connect 2 pbx Do I need for other equipment to connect
Can I put the all LCOT16 in the first pbx and use the co from any extinction in the second pbx
Can I programming the 2 pbx from the first location

 

[obtsystems]

Hi, yes you can program both systems from 1 site once you set them up on the network and connect them to the switch.
You can run all the lines through the one tde600 and access from both sides

The E1 as far as i know is going to require a modem with a e1 interface on both ends. Can you change e1 cards for a dsp 16/64 card with extra licences then it will all run from the one network port on each side

 

[tde600]

Thank you for your response and advice and I'm going to cancel the e1 card and change e1 to Dsp64 Card for each pbx