TDD not working for CPND on rollover 1

[oceannative]

Opt. 11, rel. 25 - I just changed COS from ADD to TDD for a 3904. CPND is allowed and appears on the first call, or when placing an internal call just fine, but still does not appear when the rollover receives a call when key 0 is active.

It's been a few years since I programmed, and even now it's more for fun as a side responsibility than the main job. This forum has been great for brushing up on my skills... Thanks in advance!

 

[TheWorkingMan]

Make sure you have DNDA in the CLS.

 

[mluckie1]

CLS DNDD should resolve the trouble. Dial Name Display, when the call comes up the strip the system will display the name assigned to the dialed number, key 1, and not the name of the originating call.

 

[oceannative]

CLS was DNDA, I'll try DNDD and see if that fixes it and post back. Thanks!

 

[oceannative]

Thanks mluckie1 - that did the trick. I'm the new hero on the block! now if I can just figure out to do the backup to the tape drive...