TDA200 & T1 config info

[vlpae]

Hello All. I just got this problem dumped in my lap. any help would be greatly appriciated.

I have a TDA200 currently using LCOT16. I was given a T1 card, an adtran csu ace and was told test and turn up is tuesday, get it working and kill all the copper.

According to the cut sheet the telco will pulse 3 digits. There is a block of 30 DID's attached to this circuit.

Currently ports 1-7 on the LCOT are hunt which are sent to automated attendant to call an extension ot rings to 300(operator) ports 816 are used for our inbound calling.

according to the cut sheet. the TDA-too is supposed to handle hunting. How would i ensure if an inbound call winks 200 it will route to trunk group 1, and 201 will route to trunk group 2. any idea how i should approach this?

 

[cwc3]

are you a tda dealer?

 

[cwc3]

hmm sounds like a local dealer needs to be hired
!!

 

[MILLTY]

WHERE ARE YOU?

 

[cwc3]

he is in the states he is not a certified dealer

 

[vlape]

Hi,
Got it all sorted out. No i am not a dealer, im not really a phone tech either. I used to work with some old definity systems in the early 90's with Adelphia. I have worked on Arris Cornerstone systems for a while with time warner. I now play systems administrator for a small diagnostic labratory.
I consulted with a local pana dealer and got fixed quick. Sorry it took soo long to trply to your questions, i have been busy with all the new equipment