TCP/IP conections with Wyse 2500T Winterms

[bcsinc]

Is anyone using wyse 2500T winterms to connect to a stand-alone NT 4.0 TSE SP6 server with Metaframe 1.8 SP3 using ica-tcp and a staic IP with no DNS?

I have 15 of these winterms and keep on getting a "TCP/IP Error 13 timeout" error. I tried everything I could in the setup but cannot get it to talk to the server. I can connect with the same cable to a PC using the same settings. I can't ping the winterm address from the server and I don't know how to ping from the Winterm. I'm not even sure if there is a way to ping from the winterm.

The network on the server is working fine, and as I said I can connect with a PC using the same setting on the same cable using the same settings.

Any help on this would be appreciated!

Thanks in advance,

Jim

 

[JH24]

What are the Winterms being connected to
e.g Switch, Hub???
Could be that the Winterms are not negotiating the correct speed or trying to run full duplex.


James

 

[bcsinc]

I'm using a Linksys router and switch which are supposed to auto detect speed and duplex. I have bypassed the router to diagnose. The swtiches led's are signaling a connection at 10Mbps half duplex.

I think I'm going to try a hub to be sure it's not the switch, although I have my doubts. I believe the problem is with the winterm firmware. That's why I'm asking if anyone has these terminals in an NT 4.0 SP6 Metaframe 1.0 SP3 environment.

Thanks, Jim

 

[bcsinc]

I had to connect these terminals to a hub. They would not negotiate with the auto-sensing switch, or vise-versa. There may be other manufacturers of auto-sensing switches that may work. Also, a switch that can be manually set to 10Mbps, half duplex will work.

Good Luck!

Jim