Table Design Cursor Navigation

[grinnz]

I've been away from Access for a while. In past versions when using Table Design you were able to use F6 to flip between the field definition area and the field properties area. Now using Access 2010 the F6 flips to the field properties area but then to the navigation area and one or two other stops before again landing back at the field definitions. My question is this...

Is the a keyboard shortcut in Access 2010 that after using the F6 to flip to the field properties will immediately return to the field definitions without the additional stops and key presses or how do I do F6 in reverse?

~ grinnz ~

 

[dhookom]

I haven't found a single shortcut that gets directly back to the field list.

Duane
Hook'D on Access
MS Access MVP

 

[strongm]

SHIFT F7

 

[grinnz]

Perhaps Shift-F7 works for you but certainly does not work for me. Like Duane, I too have been unable to find any key combination that returns to the field definitions.

~ grinnz ~

 

[dhookom]

I think you are stuck pressing F6 about 3-4 times.

Duane
Hook'D on Access
MS Access MVP

 

[grinnz]

I do believe that is the case. Bummer! Microsoft's infinite wisdom.

~ grinnz ~