TA7102 config guide

[fishhead64]

Can someone share a configuration guide for the TA7102?
The vendor sent one, but it's just 12 pages of how to plug it in and log into the mgmt interface. I found another doc that's 1101 pages, overkill for sure.

Looking for basic setup guide somewhere in the middle of 12-1101 pages.
Network settings, firewall rules, how to configure it, set the extensions, what to do on MiVB, etc. for two analog cordless phones.



Thanks!
Al Feinberg
MiCollab 9.6.0.105-01
Mitel Standard Linux 11.0.99
OVA 9.4.1.8
MiVoice Business Release level: 9.4
NuPoint Unified Messaging Build: 20.6.0.4.01
Revolutions 2022.2.1
MiCC 9.4.2
MiR 7.0.0-16.0
CCMWeb
PowerPlay

 

[Lundah]

Mitel KMS article HO973 is what you need. If you're a member of the Mitel User Group, your Mitel MiAccess login should give you access to Mitel KMS (Knowledge Management System).

 

[fishhead64]

Thanks, 34 pages right in the sweet spot!

I don't see anything in there about firewall rules, or ports (except SIP signaling on 5060) Will our NW engineers need to do anything on the nw port to allow this to work beyond assign a static IP?



Thanks!
Al Feinberg
MiCollab 9.6.0.105-01
Mitel Standard Linux 11.0.99
OVA 9.4.1.8
MiVoice Business Release level: 9.4
NuPoint Unified Messaging Build: 20.6.0.4.01
Revolutions 2022.2.1
MiCC 9.4.2
MiR 7.0.0-16.0
CCMWeb
PowerPlay

 

[Lundah]

the signaling will all be over UDP 5060, but the RTP voice traffic will be over a range of ports in the UDP 20000's range. The MiVB ports are listed in the Engineering Guidelines, and I think on the TA side the range is probably configurable. Put the TA7102 on the same VLAN as your desk phones and you should be good.