T1 Trouble 1

[RYLSFAN]

I am having a little trouble with a T1. 10 channels, no pri. Calls go out fine, come in and seem only to ring on the channel. I can make line61 appr&rng and the call is received fine. Can't seem to get the digits to map to the target lines i have built. *I have building target lines for a few years now so i have a fair idea of how to direct my received digits to my sets. Any ideas?


Thats not my fastball, thats my hurry up and get by you pitch... Satchel Paige

 

[jeter]

I would start by verifying the number of digits being sent by your local telephone company. They need to match you target lines.

“Reserve your right to think, for even to think wrongly is better than not to think at all”

CCNA,CCNP,Network+
Tek-TIP Member 19,650

 

[vztech]

Try making the Target line to ring&appr on your set .

The BCM monitor can show you what lines are ringing and digits

so if you set target line 222 to rcv 4555 or 555
make 222 ring&appr on your set also check your prime

then with the BCM monitor you should see something like
rcv 4555 line 222 active

It's only dialtone-VZ

 

[RYLSFAN]

61-Line061 Incoming 1-/28/07 12;55;05 4382211- ?DNIS: 2211

This is the line in my monitor. No matter how many digits i set to receive, this is what comes across.

The display in my window reads: 061 to prime so it's not even hitting the target line i built (492).



Thats not my fastball, thats my hurry up and get by you pitch... Satchel Paige

 

[RYLSFAN]

with no pri i had to set the lines to e&m wink with auto answer. auto answer being the key obviously. in case anyone was wondering.

Thats not my fastball, thats my hurry up and get by you pitch... Satchel Paige

 

[cook1082]

Try messing with the ANI setting and DINIS setting.

 

[JOSU18]

In trunk line data set answer mode to auto for did to work.It is probably set to manual at present.