T1 to T1 PRI

[Aerodesliza]

How can change my T1 to T1 PRI? Which LD I have to change and what?

Thanks

 

[trvlr1]

Not quite as simple as that, do you have a PRI circuit from the Telco to install in place of the telco T-1?

 

[phonz1]

also, do you means to support a d channel!

 

[abrasher]

1. You will need a PRI circuit to connect to. You will have to get the information from the Telco provider as to how it is configured. ( NI2, B8ZS, ESF, how many active b chnls, etc.
2. you will need a D channel daughter board, TMDI card, or PRI card depending on the switch type and your existing card
3. You will need d channel licenses or TMDI depending on the switch type.
4. You will have to delete all members of your exising loop LTM's
5. You will have to delete the route or build another one to add the PRI to the route.
6. Make sure you have ISDN = yes in CDB / NET. Also must have LDN0 defined to receive calls
7. You will have to delete your existing loop in CEQU.
8. Build new loop in Ld 17 CEQU
9. Build D channel in LD 17 ADAN
10, Build route in RDB Ld 16
11.build trunks in LD 14
12 Enable loop in LD 60
13 Enable and force download D channel in LD 96

And hope that it works.

 

[GHTROUT]

It's as easy as "How do I change my Ford to a Buick"




~~~
GHTROUT.com | Get the Input/Output Manuals | Tek-Tips FAQs | Recent Replies