T1 to PRI

[ogiebendogie]

We currently have a T1 super trunk connected to a TLU77 card. We are wanting to change over to a PRI line. Do we need to change the line card or do any programing? We are running BC8.

 

[slash50]

Which Protocols are you running?

 

[ogiebendogie]

I'm not sure what that means. Is there a print command I can use to get that information?

 

[slash50]

Which country are you in? Can you provide ROCAP and RODAP?

 

[dstrang1]

If you're in the US, you need a TLU-77/1 for PRI.

Good luck,

Dave Strang

 

[ogiebendogie]

I am in the US.

ROU SEL TRM SERV NODG DIST DISL TRAF
1 011000000000 7 0000000000 0 9 128 00151515

SIG BCAP
011100000000 00110

END


<RODAP:ROU=ALL;
ROUTE DATA
ROU TYPE VARC VARI VARO FILTER
1 TL45 H'00000003 H'00000006 H'00000007 NO

The card is just TLU77 it does not have the /1
The entire label on the card is:

ROF1375387/3
RA4
TLU77
AO5 96W47
A0500
1HKCN

Thanks for the help,
Don

 

[dstrang1]

ROF 1375387 /3 is a T-1 card........you need a /1 (ROF1375387/1) for PRI. Also, be aware that BC8 was a bad release for PRI -- 1st model year so to speak -- at least the first couple of US installs of BC8 were disasters. There may a be few patches, but I believe the majority of PRI faults w/BC8 were fixed by upgrading to BC9.

Good luck,

Dave Strang

 

[ogiebendogie]

Thanks for your help.