Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
T1 Settings
- Thread starter kb2ear
- Start date
Hi, I'm sure someone else can step you through it, but I may can help some. Are you changing from a T-1 trunk to a PRI or just the settings? If you are just changing the settings, then you will have to go to Ld 17 and change the CEQU. You may have to delete the trunks and rebuild them.
Don't forget to check your CSU for ESF/AMI settings as well. I once had an older unit that needed to be told that information and couldn't figure out why the new T1 just wouldn't work.
Pulled the CSU out of the mix and it worked fine and that's how I found it had some switches to set...
Pulled the CSU out of the mix and it worked fine and that's how I found it had some switches to set...
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question