T1 PRI Programming

[AndrewTech]

Mitel 3300 MXe III controller with T1/E1 module card installed. version 6 software.

Wanting to know if the ports on a single module can be programmed separately. I.E. Port 1 is programmed to operate as a T1 Pri where as port 2 is programmed to operate as a straight T1.

 

[kwbMitel]

As long as the functions are compatible, you can mix the protocols.

In this case, PRI and T1 are simply two flavors T1.

I am confident I've done this in the past, but not 100% sure.

**********************************************
What's most important is that you realise ... There is no spoon.

 

[caknfd]

You should be good to go. It was the NSU's that needed to be the same type of circuit

Craig