I need some programming help. I am trying to connect an SX2k to a 200ml with a T1 for msdn. I have the two switches side by side for now, but will be connecting them via a T-1 once the programming is finished. I have all the programming completed in the 2k copied the link programming from a working link to another 2k. I am not sure of the programming on the 200 side. The alarm light is out on the 200 but the 2k shows the trunks not sizeable.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
SX2K to 200ML via T1
- Thread starter bassphone
- Start date
- Thread starter
- #2
AH64Armament
Vendor
The SX200 will NOT do an MSDN link. You will have to program both sides as a T1 with E&M and use a Cross over T1 cable.
De-program the link and re-program it as an E&M and your problem should clear up.
To ensure caller ID pass along, you will also need to have Advanced Analog Networking (form 4) and the Node ID configured (form 2) of the 2d.
The ARS will also need to be configured to send the Node ID. Also you will need centralized vm to enable voicemail to work properly on the 2d.
Let me know if you need more help.
- Mark
De-program the link and re-program it as an E&M and your problem should clear up.
To ensure caller ID pass along, you will also need to have Advanced Analog Networking (form 4) and the Node ID configured (form 2) of the 2d.
The ARS will also need to be configured to send the Node ID. Also you will need centralized vm to enable voicemail to work properly on the 2d.
Let me know if you need more help.
- Mark
- Status
Similar threads
- Locked
- Question