I have a SX200ICP 3.1, with one quad DSP module. On my analog phones I sometimes get complaints about unable to break dial tone from an analog phone. Through testing have determined that it is traffic sensitive and seems to only occur if 2 phones come off hook at exactly the same time and try to dial. have watched each receiver and the same ones never fail twice. It fails on any and all of them when it does. Failure rate is about one failure in 30 trys. Could this be a bad DSP module or do I have something programmed wrong in form 4 or another form that would allocate receivers to something else. It does get worse during peak traffic periods and seems to have appeared after adding a PRI.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
SX200ICP Unable to break dialtone
- Thread starter tt1tom
- Start date
pandabear1
Technical User
what do you have programed in form 4 option 59?
- Thread starter
- #4
- Thread starter
- #5
I changed the DSP and the problem is back. It seems to appear exactly 2 weeks after any kind of a reset. It will work fine for 2 weeks and then start failing again. Any other sugestions? I have busied out receivers and the problem just moves to other receivers.
pandabear1
Technical User
are there any logs?
just a shot in the dark, but do all your cos have option 702 overwrite buffer enabled?
just a shot in the dark, but do all your cos have option 702 overwrite buffer enabled?
- Status
Similar threads
- Locked
- Question