SX2000 config for T1

[techuser100]

we have a SX2000 and want to connect a T1.
universal T1 card is installed and configured.
Type: universal t1
> Signal protocol: msdn-dpnss
> BRI Mode: none
> Far end connect: Main PBX
Link Desc: dpnss, dsx-1, nil

T1 settings from provider:
T1 B8ZS line coding, with ESF Framing
PRI encoding is NI2/National

what are the setting required in the SX2000?
thanks in advance.

 

[techuser100]

A bit more detail.
in the SX2000 Digital Link configuration a DS1 Formatter card provides support for D8ZS/ESF.
Do i need a DS1 card along with the Universal T1 card?
Can a CSU/DSU be installed between the Mitel and the T1?
I am getting ring tone when dialing out the T1, then a recording, "message 3DT1" or "message 4DT1"
thanks.

 

[techuser100]

sorry for not providing the follow detail with my first post.
the t1 card is MC270AA
no IMAT
lightware MS2013-F-NA-00 SX.U03.9.9
I have made some progress.
calls are going out and coming in.
however, we have been using circuits requiring a 9, the new T1 does not.
i would like to continue to require the 9 and have it absorbed, but the Digit Mod/Absorb config isn't working.
any suggestions?
thanks.