SX2000 -CEPT II card taxing my brain

[LoopyLou]

Trying to install a CEPT II formatter card in a LW 34 SX2000. Card is not recognized by the SX2000. Trying to remember what issues I ran into many moons ago when I last did this. Any thoughts? Failing that may reflash the card but can't find the procedure on line anymore to do that.

I'd tell you a UDP joke but I'm afraid you won't get it. TCP jokes are the best because you always get them.

 

[techymitel]

Hi, I think you need to program it as 'Universal E1' and not as 'CEPT card'

It may self upgrade / downgrade first time it establishes a message link to the SX2000 - don't remove it during this process!

Do a 'mess sub' to see what's happening. 'boot' being displayed for up to 20 minutes would indicate it is talking to main control and is upgrading.

You need a different stub assembly from the usual one as well I think.

techymitel

 

[LoopyLou]

Programmed as universal E1 and have the right interface.


I'd tell you a UDP joke but I'm afraid you won't get it. TCP jokes are the best because you always get them.

 

[techymitel]

You will have to program it in the digital link assignment and assign trunks to it as well before the message link establishes.

Sometimes the CEPT card needs a re-seat after you've programmed the trunks.

Or a dodgy card?

CEPT cards are usually a piece of cake.

techymitel

 

[LoopyLou]

three different cards do the same thing. USed the recovery process to flash cards and now everything looks ok.

I'd tell you a UDP joke but I'm afraid you won't get it. TCP jokes are the best because you always get them.