Sx200 icp ez232 and printer setup

[telesco]

Have an sx 200 icp, have ez232 serial to ip converter.
Can't get the printer to print, already setup ez232 with correct ip #s.

 

[JimHilton]

Hi, are you sure the baud rate is matched to the controller? And have you confirmed that the controller is actually outputting any data?

I believe the values you need are:

9600,N,8,1

Jim

 

[JimHilton]

DOH! Also dont' forget the port of the printer. Typically its 9100 (HP standard). Most printers will accept that port.

Jim

 

[stsguy]

chech form 34

 

[telesco]

What are the correct ip addresses?
Gateway is gateway of network or ip of sx 200?
remote address is any ip or does this need to be sx200?