May 27, 2010 #1 telesco Vendor Jan 25, 2009 72 0 0 US Have an sx 200 icp, have ez232 serial to ip converter. Can't get the printer to print, already setup ez232 with correct ip #s.
Have an sx 200 icp, have ez232 serial to ip converter. Can't get the printer to print, already setup ez232 with correct ip #s.
May 27, 2010 #2 JimHilton IS-IT--Management Jun 20, 2009 346 0 0 CA Hi, are you sure the baud rate is matched to the controller? And have you confirmed that the controller is actually outputting any data? I believe the values you need are: 9600,N,8,1 Jim Upvote 0 Downvote
Hi, are you sure the baud rate is matched to the controller? And have you confirmed that the controller is actually outputting any data? I believe the values you need are: 9600,N,8,1 Jim
May 27, 2010 #3 JimHilton IS-IT--Management Jun 20, 2009 346 0 0 CA DOH! Also dont' forget the port of the printer. Typically its 9100 (HP standard). Most printers will accept that port. Jim Upvote 0 Downvote
DOH! Also dont' forget the port of the printer. Typically its 9100 (HP standard). Most printers will accept that port. Jim
Jun 11, 2010 Thread starter #5 telesco Vendor Jan 25, 2009 72 0 0 US What are the correct ip addresses? Gateway is gateway of network or ip of sx 200? remote address is any ip or does this need to be sx200? Upvote 0 Downvote
What are the correct ip addresses? Gateway is gateway of network or ip of sx 200? remote address is any ip or does this need to be sx200?