SX200 ICP AX>CO Trunk Software State (SWSTAT)

[jabbo99]

I have a system using four trunks. The last two trunks have a status of "stowd" as there SWSTAT. The first trunk is idle while the second trunk was talking. After restarting the PBX, the first two trunks are now showing that they are busied out and the last two trunks that had stowd are now idle. What is the definition of "stowd".

Thank you

 

[jabbo99]

 

[kwbMitel]

On Hold or Parked

**********************************************
What's most important is that you realise ... There is no spoon.

 

[jabbo99]

Thanks kwbMitel. Curious, is there a way to clear the feature from MTCE?

 

[jabbo99]

Clear Feature All perhaps?

 

[jabbo99]

Ahh, did some reading and it appears as though the Clear Feature All from MTCE will only clear Call Forwarding, DnD and CAll Back...

 

[kwbMitel]

You could busy out the trunk and return to service.

I believe there may be a reset trunk option but very vague on that. It will all be under the diagnostics for the trunk

**********************************************
What's most important is that you realise ... There is no spoon.

 

[jabbo99]

I'll give that command a shot. Thanks

 

[jabbo99]

I did not find a command called reset trunk. I did find one called Disc_Trunk. I applied it to both trunks and they're now idle.

Thank you