SX200 5.0 AX feature access code on speed dial key

[Crowtalks]

Have a SX200 AX 5.0 system where the customer is wanting to be able to press a single key to access their speedcalls (abbreviated dialing)

This feature is available in the 3300, 5000, Avaya, ect. but Mitel Tech Support couldn't get *24 to program behind a speedcall key, even though Mitel Systems Engineering says you can do it.

Has anyone successfully done this?

Jim

"If I had known it would turn out like this, I would have become a locksmith" Albert Einstein

NCSS NCTS NCTE CS1000E Avaya IP Office
Mitel 3300 Basic & Advanced 5000 NuPoint I&M MiCloud

 

[pandabear1]

change it to either 24 or #24 and it will work

 

[pandabear1]

it is the * the system doesn't like when you program against a key on a phone

 

[Crowtalks]

Thanks, I'll try that tomorrow AM

Jim

"If I had known it would turn out like this, I would have become a locksmith" Albert Einstein

NCSS NCTS NCTE CS1000E Avaya IP Office
Mitel 3300 Basic & Advanced 5000 NuPoint I&M MiCloud

 

[kwbMitel]

Actually it will work if you input as **24

Speedcalls have lots of * codes so if you want to dial a * you need **

**********************************************
What's most important is that you realise ... There is no spoon.

 

[Crowtalks]

Thanks gentlemen, it works!

Jim

"If I had known it would turn out like this, I would have become a locksmith" Albert Einstein

NCSS NCTS NCTE CS1000E Avaya IP Office
Mitel 3300 Basic & Advanced 5000 NuPoint I&M MiCloud