SV9100 External Paging using AUX1 on GCD-CP10 1

[thomen00]

I have seen a couple posts in this forum regarding this but didn't see specifics on the 3.5mm cable. I just want to verify if the cable is to be mono or stereo and also is there a specific length needed for the male end? I've seen various lengths and just want to make sure we are using the correct one. Second question can you explain the difference between external all call paging and external group paging? Thank you

 

[CoralTech]

It's mono. Always mono. External all call opens up all the external interfaces. Group is just that, a group vs all.

These are the bomb BTW. Make life 100x easier.

https://www.amazon.com/CERRXIAN-Ter...-2-spons&sp_csd=d2lkZ2V0TmFtZT1zcF9hdGY&psc=1

I would suggest if you have balance issues off the processor, and you have available digital ports that you get the paging adapter. We never use the processor page port unless absolutely needed.

 

[thomen00]

I assumed mono from my BCM days but you now how assuming goes! Thanks for the tip on the 3.5mm adapter. Just curious about the page port on the processor though, you see a lot of issues using it? Thanks!

 

[CoralTech]

Not many issues but the adapter seems to work better..plus it's not putting anything into the main processor.