Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

SV8300 Multiple calls on single DID not working

Status
Not open for further replies.

deadinthefield

Programmer
Jan 11, 2024
8
AE
Hi Everyone,

I am new to the forum and new to NEC systems.

Problem is System is showing number busy to the second external incoming call.

I have created 3 Vitual line numbers.
Assigned then for incoming DID in 7601 and 7602.
Assigned 3 programmable keys on the 3 phones with the virtual line numbers.

1st call is working, but on second call it shows busy.

Any help will be really appreciated.

 
Be sure to set up a rollover virtual group
Example assign DID in 7601 and 7602 to 2100 if extension do not match DID
2100 Fwd busy to Virtual 3100, Fwd N/A to VM pilot.
3100 fwd busy to 4100, FWD N/A to VM Pilot
4100 Fwd busy /NA to VM pilot.

This will allow up to 3 callers at your phone and go No answer to VM if you choose.
 
@mitchell70,

Thank you for the reply back.

Just now I found out that I had created UCD Group instead of Hunt Group.

So instead of 170> I have added the Virtual Number in Hunt group 180>

And It is working now.

Thanks Again.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top