SV8100 Night Mode Endpoints Setup?

[heiff]

Hi,

I'm trying to change the endpoints when an SV8100 is in night mode, but I can't wrap my head around the programming - where do I find and change this information? When I look in section 12-XX, there doesn't seem to be anything that controls things in a "when system is in Night 1, send calls to the following endpoints" kind of way. Any guidance would be very much appreciated.

Thanks,

Ian

 

[cayres1003]

are you trying to re-direct pots lines or pri with night mode. They are in different places.

 

[belevedere]

Program 12-05-01 assigns extensions to a Night service group.

Program 12-06-01 assigns trunks to a Night service group.

 

[heiff]

Hi, Thanks for the replies. I'm looking in 12-05, and it shows a table on the left of consecutive extensions. The Night Mode Group on each is set to "1" - and is set that way no matter what extension I select from the dropdown menu on the right side of the page. This implies that every extension rings when the system is in night, but that can't be right.